Setting Jumpers; Jumper Settings - ECS P4IBAS2 Manual

Jumper Settings

Jumper Type Description
JP1 3-pin Clear CMOS
JP2 2-pin BIOS Protect
JP1 – Enables you to clear the BIOS. Refer to the following instruc-
tions:
1. Turn the system off.
2. Remove all ATX power connectors.
3. Short pins 2 and 3 on JP1.
4. Return the jumper to the normal setting.
5. Plug in all ATX power connectors.
JP5 – Enables and disables the BIOS from being updated (flashed).
Set the jumper to enabled if you are going to update your BIOS. After
updating the BIOS, return it to the disabled setting. For instructions on
updating the BIOS refer to Chapter 3.
A p p
A p p

Setting Jumpers

Setting (default)
1-2: Normal
1
2-3: Clear
Open: Disable
Short: Enable
e n d i x A
e n d i x A
JP1
JP2