ECS P4IBAS2 Manual page 58

POWER ON Function (Hot KEY)
Enables you to set power on parameters. The default setting
enables you to use a hot key to turn on the system.
KB Power ON Password (Enter)
When the POWER ON Function is set to Password, use this
item to set the password.
Hot Key Power ON (Ctrl-F12)
When the POWER ON Function is set to Hot KEY, use this
item to set the hot key combination that turns on the system.
Onboard FDC Controller (Enabled)
This option enables the onboard floppy disk drive controller.
Onboard Serial Port 1 (3F8/IRQ4)
This option is used to assign the I/O address and interrupt re-
quest (IRQ) for the onboard serial port 1 (COM1).
Onboard Serial Port 2 (2F8/IRQ3)
This option is used to assign the I/O address and interrupt re-
quest (IRQ) for the onboard serial port 2 (COM2).
UART Mode Select (Normal)
This field is available if the Onboard Serial Port 2 field is set to
any option but Disabled. UART Mode Select enables you to
select the infrared communication protocol-Normal (default),
IrDA, or ASKIR. IrDA is an infrared communication protocol
with a maximum baud rate up to 115.2K bps. ASKIR is
Sharp's infrared communication protocol with a maximum
baud rate up to 57.6K bps.
52