Table of Contents
Advertisement
Faults and what to do about them.
en
Information on the display
panel
Display
YES
NO
E:17
E:18
E:23
E
x
:
.
Other displays
Faults and what to do about
them.
Faults
Water is running out.
Water not flowing in.
Detergent not dispensed.
Washing machine door
cannot be opened.
Programme does not
start.
28
Cause/Remedy
The washing machine door is unlocked. It is possible to add laundry.
Due to the high temperature in the drum, the washing machine door cannot
■
be opened. Wait until the temperature drops.
Due to the high level of water in the drum, the washing machine door can-
■
not be opened. Drain the water e.g. select the 0 [ Spin/Drain pro-
gramme (if only a drain cycle is required, set rpm (spin speed) to - - -).
Turn on tap fully, supply hose kinked/jammed; water pressure too low, clean fil-
ter ~ Page 27
Drain pump blocked; clean the drain pump~ Page 26.
Drainage hose/outlet pipe blocked; clean drainage hose on the
siphon~ Page 26.
Water in the base trough, appliance leaking. Call after-sales service.
~ Page 30
If childproof lock is active, deactivate it ~ Page 20
~ flashes: Too much foam detected?~ Page 28
~ flashes: Mains voltage too low ~ Page 24
~ flashes: Undervoltage during the washing programme. The programme
duration is extended. ~ Page 24
Switch off the appliance, wait for five seconds and switch it back on again. If the
indicator appears again, call the after-sales service ~ Page 30
Cause/Remedy
Attach/replace the drain hose correctly.
■
Tighten the screw-fitting on the supply hose.
■
Start/Reload not selected?
■
Tap not open?
■
Filter blocked? Clean the filter. ~ Page 27
■
Supply hose kinked or trapped?
■
Safety function active. Stop programme?
■
– – – (Rinse stop = without final spin cycle) selected? ~ Page 21
■
Can be opened by emergency release only?
■
Start/Reload or Ready in time selected?
■
Washing machine door closed?
■
Childproof lock active? Deactivate. ~ Page 20
■
Advertisement
Table of Contents
