Table of Contents
Advertisement
Filter in the water supply
blocked
First, reduce the water pressure in the
supply hose:
Turn off the tap.
1.
Select any programme (except 0 [
2.
Spin/Drain).
Select Start/Reload. Leave
3.
programme for approx. 40 s.
Turn the programme selector to Off.
4.
Remove the mains plug.
Clean the filter on the tap:
5.
Disconnect the hose from the water
tap.
Clean the filter with a small brush.
Clean the filter on the back of the
6.
appliance:
Remove the hose from the rear of
the appliance.
Take out the filter with pliers and
clean it.
Connect the hose and check for
7.
leaks.
Faults and what to do about them.
3
Faults and what to do
about them.
s
F a u l t
a n d
w h a t
Emergency release
e.g. in the event of a power cut
The programme continues running
when the power supply is restored.
However, if the laundry has to be
removed, the washing machine door
can be opened as follows:
:
Warning
Risk of scalding!
When you are washing at high
temperatures, there is a risk of scalding
if you come into contact with hot
detergent solution and laundry.
If possible, leave it to cool down.
:
Warning
Risk of injury!
You may injure your hands if you reach
into the drum while it is rotating.
Do not reach into the drum while it is
rotating. Wait until the drum has
stopped rotating.
Caution!
Water damage
Any escaping water may cause water
damage.
Do not open the washing machine door
if water can be seen through the glass.
Turn the programme selector to Off.
1.
Remove the mains plug.
Drain the water.
2.
Pull down emergency release with a
tool and release.
The washing machine door can then be
opened.
t o
d o
a b o u t
en
t h e m .
27
Advertisement
Table of Contents
