NEC N8800-184F Maintenance Manual page 45

Chapter 1 Maintenance
4. Start the I/O module stopped in step 3.
Run the following command to start the stopped I/O module 0.
# cd /opt/ft/bin
# ./ftsmaint bringup 10
When the I/O module is started, diagnosis of I/O module, and duplication of I/O module are
performed.
The status LED of I/O module changes as shown below:
[Indications of status LED]
Immediately after the I/O module startup until the completion of diagnosis:
(1)
(2)
(3)
When duplication of disks is started after the completion of diagnosis of I/O module:
(1)
(2)
(3)
After the completion of disk duplication and when the I/O modules are duplicated:
(1)
(2)
(3)
LED
PRIMARY LED
DISK ACCESS LED
LED
System FT LED
LED
PRIMARY LED
DISK ACCESS LED
LED
System FT LED
LED
PRIMARY LED
DISK ACCESS LED
LED
System FT LED
Express5800/R320d-E4, R320d-M4 Maintenance Guide (VMware 5.5)
5. Checking the Duplicating Operation of Modules
I/O module 0
–
–
System
–
I/O module 0
–
Amber or Green blinking
(Green when accessing to
HDD)
System
–
I/O module 0
–
Green
System
Green
I/O module 1
Green
Amber or Green blinking
(Green when accessing to
HDD)
I/O module 1
Green
Amber or Green blinking
(Green when accessing to
HDD)
I/O module 1
Green
Green
45