Log Placement (7 Log Set) - Dvd(42,48)Fp - Empire Comfort Systems MILLIVOLT DVD32FP30N-3 Installation Instructions Manual

loG placeMeNt (7 loG set) - DVD(42,48)Fp

This fireplace is supplied with a set of seven ceramic fiber logs. Do
not handle these logs with your bare hands. Always wear gloves to
prevent skin irritation from ceramic fibers. After handling logs, wash
your hands gently with soap and water to remove any traces of fiber.
The positioning of logs is critical to safe and clean operation of this
fireplace. Sooting and other problems may result if the logs are not
properly and firmly positioned in the fireplace. Please refer to Figure
57 and Figure 58 and corresponding WARNING when completing
following log placement steps.
1. Remove top louver, grasp louver, lift and pull forward.
2. Lower bottom louver, lift and hinge forward.
3. Release two glass frame spring clamps at bottom of firebox
4. Remove glass frame spring assembly.
5. Place front logs (#1, #2, and #3) between grates and main
burner. Align notches on front logs with locator tabs in base.
6. Place middle log (#4) between front and rear loop of burner.
Note: do not place on top of pilot assembly.
7. Place rear log (#5) on rear log shelf. Bottom flange is to be
placed between the log shelf and burner tube.
8. Place bottom "Y" branch (#6) onto flat areas of middle log (#4)
and bottom end of "Y" branch to the back side of the grate tang
(4th one from the left).
9. Place top branch (#7) onto flat area of rear log (#5) and over
the front of "Y" branch.
10. Place decorative rock in front of grates and sides of main burner.
atteNtioN: Do not place decorative rock on logs or on burner.
The decorative rock should only be placed on the fireplace floor.
11. After all logs are properly positioned, place small "dime" size
pieces of Rockwool lightly across the front burner tube ports.
Place the ember material (Rockwool pieces) side by side. Do
not stack more than one layer of embers across the burner
ports. See Figure 58.
12. Replace glass frame onto firebox.
13. Secure the two glass frame spring clamps at bottom of firebox.
14. Align the tabs on top louver brackets with slots in front posts
to secure top louver.
15. Close bottom louver. Lift slightly to engage the end tabs into
the slots in fireplace sides to close louver panel.
38713-5-1019
Warning: Failure to position the parts in accordance with this
diagram or failure to use only parts specifically approved
with this appliance may result in property damage or
personal injury.
Attention: Do not use Figure 57 or Figure 58 to order logs. Refer to
parts lists and parts views on pages 60 to 63 to order logs and/or
ember material for your appropriate fireplace model.
Figure 57
Figure 58
Page 37