Panasonic PT-LB10NTU Service Manual page 17

7. While disconnecting the 2 connectors, remove the WL-P.C.Board
from the A-P.C.Board block (PT-LB10NTU/E only).
8. Unscrew the 10 screws and remove the connector metal fittings.
Note:
- Because the S2-P.C.Board block is attached, work carefully when
removing the connector metal fittings.
9. While disconnecting the connector between A- and S2-
P.C.Boards, remove the S2-P.C.Board block.
7.4. Removal of WL-P.C.Board (PT-LB10NTU / E only)
Remove the WL-P.C.Board according to the steps 1 through 6 in the section 7.3. "Removal of A-
P.C.Board".
7.5. Removal of S1-P.C.Board
1. Remove the upper case according to the section 7.2. "Removal of
Upper Case".
PDF created with pdfFactory Pro trial version
17
www.pdffactory.com