Table of Contents
Advertisement
Always use common sense and be cautious
•
when using pump. It is not possible to anticipate
every situation that could result in a dangerous
outcome. Do not use this pump if you do not
understand these operating instructions or you
feel the work is beyond your capability; contact
Tool or a trained professional for
MILWAUKEE
®
additional information or training.
•
Maintain labels and nameplates. These carry
important information. If unreadable or missing,
contact a MILWAUKEE
replacement.
ADDITIONAL BATTERY SAFETY RULES
To reduce the risk of fire, personal
WARNING
injury, and product damage due to
a short circuit, never immerse your tool, battery
pack or charger in fluid or allow a fluid to flow inside
them. Corrosive or conductive fluids, such as
seawater, certain industrial chemicals, and bleach
or bleach-containing products, etc., can cause a
short circuit.
Do not charge non-rechargeable
WARNING
batteries.
SYMBOLOGY
V
Volts
Direct Current
No Load Revolutions per Minute (RPM)
Read Operator's Manual
Regulatory Compliance Mark (RCM).
This
regulatory requirements.
Do not dispose of electric tools
together
material. Electric tools and electronic
equipment that have reached the end
of
their
separately
environmentally compatible recycling
facility.
SPECIFICATIONS
Cat. No. ............................................. M12 BSTP 0
Volts........................................................... 12V DC
Battery Type .................................................M12™
Charger Type................................................M12™
Max Flow Rate........................ 34 Litres per minute
Fitting
..................................................3/4"-14 BSPT
Application
Max Water Temperature ................. 60°C (140°F)
Max Air Temperature ...................... 40°C (104°F)
Recommended Ambient
Operating Temperature ................... -17°C to 51°C
service facility for a
®
product
meets
with
household
life
must
be
and
returned
FUNCTIONAL DESCRIPTION
1
2
6
1. ON/OFF switch
2. Handle
3. Submersion line
4. Lift tube
WARNING
manual supplied with your charger and battery.
Removing/Inserting the Battery
To remove the battery, push in the release buttons
and pull the battery pack away from the tool.
WARNING
To insert the battery, slide the pack into the body
of the tool. Make sure it latches securely into place.
WARNING
may be hazardous.
• Use a hose with a
applicable
leaking, ensure the hose has a properly-working
o-ring in its fitting.
•
For best results, a heavy duty hose should be
used to prevent the hose from collapsing. Use a
waste
shortlength, large diameter hose, such as a 1.8 m
(6') long, 1.9 cm (3/4") inner diameter garden
hose. Longer or thinner hoses may reduce
collected
performance and flow rate.
to
an
• A regular garden hose may be used as an outlet
hose.
• Make sure connections are tight.
•
Hand thread the outlet hose onto the pump's
hosefitting. Do not overtighten, or the threads may
be damaged on the fitting or hose.
To remove the HydroPass filter, hand twist the filter
anti-clockwise and pull it away from the rest of the
tool.
To install the HydroPass filter, line the filter up at the
end of the lift tube and hand twist the filter clockwise
until it is fully connected with the rest of the tool. Do
not overtighten.
NOTE: The HydroPass filter must be installed to
use the pump.
3
3
4
7
ASSEMBLY
Recharge only with the charger
Always remove the battery pack
any time the tool is not in use.
recommended for this tool. Others
Connecting the Hose
3/4"-14 BSPT
Removing/Installing the
HydroPass Filter
5
5. HydroPass filter
6. Battery bay
7. Hose fitting
-
fitting. To prevent
Advertisement
Table of Contents
