Using The Show Interfaces Command - Cisco PA-POS-1OC3 Installation And Configuration Manual

Cisco systems port adapter installation and configuration guide
Table of Contents

Advertisement

Checking the Configuration

Using the show interfaces Command

Display status information (including the physical slot and interface address) for the interfaces you
specifyusing the show interfaces command.
For complete descriptions of interface subcommands and the configuration options available, refer to the
publications listed in the
The ouputs that appear in this document may not match the output you receive when running these
Note
commands. The outputs in this document are examples only.
The following sections provide output of the show interfaces command for some of the supported
platforms:
Cisco 7200 VXR Series Routers—Example Output of the show interfaces Command
Following is an example of the show interfaces pos command for a PA-POS-1OC3 in port adapter slot
4 of a Cisco 7200 VXR router:
Router# show interfaces pos 4/0
PE3#sh int pos4/1
POS4/1 is down, line protocol is down
Hardware is Packet over Sonet
Internet address is 142.50.8.3/24
MTU 4470 bytes, BW 155000 Kbit, DLY 100 usec,
Encapsulation HDLC, crc 16, loopback not set
Keepalive not set
Scramble disabled
Last input never, output never, output hang never
Last clearing of "show interface" counters 3d23h
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output queue: 0/40 (size/max)
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
For the Cisco 7206 VXR router shelves in the Cisco AS5800 Universal Access Router, the show
Note
interfaces pos command requires a shelf number in the format show interfaces pos
shelf-number/port-adapter-slot-number/interface-port. For example, the command show interfaces pos
5/3/0 specifies the OC-3 interface of a PA-POS-1OC3 in port adapter slot 3 of router shelf 5.
PA-POS-1OC3 Single-Port Port Adapter Installation and Configuration Guide
4-20
"Related Documentation" section on page
Cisco 7200 VXR Series Routers—Example Output of the show interfaces Command, page 4-20
Cisco 7201 Router—Example Output of the show interfaces Command, page 4-21
Cisco 7301 Router—Example Output of the show interfaces Command, page 4-21
VIP in Cisco 7500 Series Routers—Example Output of the show interfaces Command, page 4-22
reliability 255/255, txload 1/255, rxload 1/255
0 packets input, 0 bytes, 0 no buffer
Received 0 broadcasts (0 IP multicast)
0 runts, 0 giants, 0 throttles
0 parity
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
0 packets output, 0 bytes, 0 underruns
0 output errors, 0 applique, 20 interface resets
0 output buffer failures, 0 output buffers swapped out
0 carrier transitions
Chapter 4
Configuring the PA-POS-1OC3
iv.
OL-6514-04

Advertisement

Table of Contents
loading

This manual is also suitable for:

Pa-pos-2oc3

Table of Contents