Configuring The Pa-Pos-1Oc3; Using The Exec Command Interpreter - Cisco PA-POS-1OC3 Installation And Configuration Manual

Configuring the PA-POS-1OC3

The following instructions apply to all supported platforms. Minor differences among the
platforms—with Cisco IOS software commands—are noted.
This chapter contains the following sections:
•
•
•
•
•
•
•
•

Using the EXEC Command Interpreter

You modify the configuration of your router through the software command interpreter called the EXEC
(also called enable mode). You must enter the privileged level of the EXEC command interpreter with
the enable command before you can use the configure command to configure a new interface or change
the existing configuration of an interface. The system prompts you for a password if one has been set.
The system prompt for the privileged level ends with a pound sign (#) instead of an angle bracket (>).
At the console terminal, use the following procedure to enter the privileged level:
At the user-level EXEC prompt, enter the enable command. The EXEC prompts you for a
Step 1
privileged-level password.
Router> enable
Password:
Enter the password (the password is case sensitive). For security purposes, the password is not displayed.
Step 2
When you enter the correct password, the system displays the privileged-level system prompt (#).
Router#
OL-6514-04
Using the EXEC Command Interpreter, page 4-1
Configuring the Interfaces, page 4-2
Customizing the Configuration, page 4-8
Checking the Configuration, page 4-12
Push/Pull Mode Description, page 4-24
PA-POS-1OC3 Statistics Counters, page 4-24
PA-POS-1OC3 Error Messages, page 4-25
Making a Back-to-Back Connection, page 4-25
C H A P T E R
PA-POS-1OC3 Single-Port Port Adapter Installation and Configuration Guide
4
4-1