Table of Contents
Advertisement
Chapter 2
Preparing for Installation
Laser Safety
The multimode aperture has a Class 1 laser warning label, as shown in
Figure 2-1
CLASS 1 LASER PRODUCT
Class 1 laser product. Statement 1008
Warning
Invisible laser radiation may be emitted from disconnected fibers or connectors. Do not stare into
Warning
beams or view directly with optical instruments. Statement 1051
FCC Class A Compliance
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant
to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial environment. This equipment generates,
uses, and can radiate radio-frequency energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful interference, in which case users will be
required to correct the interference at their own expense.
You can determine whether your equipment is causing interference by turning it off. If the interference
stops, it was probably caused by the Cisco equipment or one of its peripheral devices. If the equipment
causes interference to radio or television reception, try to correct the interference by using one or more
of the following measures:
•
•
•
•
PA-POS-1OC3 is designed to meet these requirements. Modifications to this product that are not
Caution
authorized by Cisco Systems, Inc. could void the various approvals and negate your authority to operate
the product.
OL-6514-04
Class 1 Laser Product Warning Label on the PA-POS-1OC3
LASERPRODUKT DER KLASSE 1
PRODUIT LASER DE CLASSE 1
PRODUCTO LASER CLASE 1
Turn the television or radio antenna until the interference stops.
Move the equipment to one side or the other of the television or radio.
Move the equipment farther away from the television or radio.
Plug the equipment into an outlet that is on a different circuit from the television or radio. (That is,
make certain the equipment and the television or radio are on circuits controlled by different circuit
breakers or fuses.)
PA-POS-1OC3 Single-Port Port Adapter Installation and Configuration Guide
FCC Class A Compliance
Figure
2-1.
2-11
Advertisement
Table of Contents
