Table of Contents
Advertisement
6. Pull up the main board and remove it.
CAUTION: If the board is to be checked in
order to evaluate the warranty, it should be
placed in a bag with protection against ESD
(electrostatic discharge).
7. Fit the new main circuit board.
8. Refit the plastic clip.
9. Connect all cables to the main circuit board. Check
that the cables are connected to the correct place.
10. Reassemble the upper chassis and the body
To assemble the upper chassis and
system. Refer to
the body system on page 27 .
11. Connect the product to Autocheck. Select the
correct serial number in the log book. Autocheck
automatically transfers the operating information
saved in the log book.
12. If the current product for any reason is not in the
log book in Autocheck, the serial number must be
entered manually. The serial number is printed on
the rating plate on the inside of the hatch.
CAUTION: Check that the correct serial
number is entered. It can only be entered
once.
13. If the main circuit board is replaced when
troubleshooting and you are not sure if the new
main circuit board will be kept in the relevant
product, it is possible to temporarily program the
main circuit board in a so-called Service Mode.
Programming a new main circuit board on
Refer to
page 14 .
6.8.3 To replace the rear sensor module
The circuit board in the rear sensor module contains
the rear loop sensor, the rear lift sensor and the STOP
1413 - 003 - 17.01.2022
sensor. The sensors cannot be replaced separately. The
entire rear sensor module must be replaced as a unit.
1. Disassemble the body system. Refer to
disassemble the body system on page 16 .
2. Disassemble the upper chassis. Refer to
disassemble the upper chassis on page 18 .
3. Disconnect the power cable and the signal cable
from the rear sensor module.
4. Remove the cables from the 2 clips that hold the
cables in position.
®
5. Only for Husqvarna
lower chassis.
To
To
, loosen the 2 screws into the
Repair instructions - 21
Advertisement
Table of Contents
