Quick Info (Limited Tools Menu) - Husqvarna Automower 115H Workshop Manual

Demo : Demo mode is used for installations in shops
•
or exhibitions. The blade disc does not rotate and
the product alternates between short periods of
operation, docking and charging. Demo mode can
be enabled and disabled in Autocheck or in the
Tools menu.
WARNING: The blades must not be
installed when the product operates for
demonstration in public areas such as
shops and exhibitions.
Installation lock : If the installation settings lock is
•
activated, it is not possible to change any settings in
Installation menu.
the
Note: The installation settings lock must be
deactivated to be able to change any of the
installation settings in the main menu.
Temporary disable charging protection: For safety
•
reasons the product is set to not charge if the
charging current is too low. Use this function
to temporary remove the protection. The product
charges with a lower current than it is specified for
the product.
4.3.6 Tools - Calibrate
Tools - Calibrate menu shows:
The
Guide calibration : The guide wire is calibrated
•
automatically during the first start-up sequence. A
manual calibration may however be necessary, if for
example the charging station installation is changed.
Place the product in the charging station and start
the calibration.
Tilt sensor calibration : If the product does not
•
operates as expected in slopes it might help to
calibrate the tilt sensor. Place the product on a
horizontal surface and start the calibration.

4.4 Quick info (Limited Tools menu)

Quick info menu is a limited Tools menu .
The
When the start page or the main menu is displayed:
1. Push and hold down the Menu button for 2 seconds
Quick info menu.
to access the
4.4.1 Quick info - Info
Quick info - Info menu has the same sub-menus as
The
Tools , except for the sub-menu Motors . Refer to Tools
in
menu (Expert mode) on page 8 .
4.4.2 Quick info - History
The Quick info - History menu has 2 sections: Messages
Search times .
and
History - Messages menu shows:
The
Fault messages : The 50 last fault messages
•
Info messages : The 50 last information messages.
•
1413 - 003 - 17.01.2022
History - Search times menu show the same sub-
The
Tools - History, total - Search times . Refer
menus as in
Tools - History, total on page 9 .
to
4.4.3 Quick info - Advanced
The Quick info - Advanced menu shows the Calibrate
menu. It has the same sub-menus as in
Calibrate . Refer to Tools - Calibrate on page 11 .
Tools -
Special menus - 11