Chapter 2
Installing the Cisco WAN Modeling Tools
Enter the cd command to move to one of your project directories:
Step 3
Enter the nmt command to start NMT:
Step 4
nmt
Note
Removing NMT
The
Installing a Cisco WAN Modeling Tools Sub-application
This section provides instructions for installing the following Cisco WAN Modeling Tools
sub-applications:
•
•
•
To install the sub-applications on a UNIX platform, see the
sub-applications on a UNIX
"Installing the SSI on a PC
Note
This procedure is necessary only if you used the -NMT option with NMTlink.
The procedures in the sections that follow are for accessing, loading, and linking the applications to
project directories.
OL-10426-01, Rev. A0
cd project_name
Use the nmt -d command to start the program if you need to modify system parameters to ranges
outside the scope of the current product line. This option adds two additional selections to the
Execute menu: Internal Set for Switches/Links and Network Internal Setting.
command removes all NMT subcomponents from the program.
nmtrel
the Configuration Extraction Tool (CET)
the Third Party Interface (TPI)
the SpreadSheet Interface (SSI)
Platform" section that follows. To install the SSI on a PC platform, see the
Platform" section, later in this chapter.
"Installing the Cisco WAN Modeling Tools
Cisco WAN Modeling Tools Guide
Removing NMT
2-7