Table of Contents
Advertisement
en Appliance door
6.
Remove the seal from below the pane. To do this,
pull the seal and remove it upwards. Remove the
pane.
7.
Pull the lower pane diagonally upwards and out.
8.
Never remove the screws that are located on the
right and left of the sheet metal part.
25.4 Fitting the door panes
When fitting the panes, ensure that, on both panes, the
lettering "top right" is not upside down at the bottom
left.
1.
Insert the lower pane with the no. 1 downwards at
an angle.
30
2.
Insert the middle pane with no. 2 inwards.
3.
Fit the retaining clips onto the right- and left-hand
side of the pane, aligning them so that the springs
are over the screw holes. Screw the retaining clips
in place.
4.
Insert the seal below the pane.
5.
Hold the top pane in both brackets and insert it at
an angle towards the back.
Ensure that the seal does not slip backwards.
Advertisement
Table of Contents
