Table of Contents
Advertisement
8 Before using for the first time
Configure the settings for initial start-up. Clean the ap-
pliance and accessories.
8.1 Initial configuration
You have to implement settings for the initial configura-
tion before you can use your appliance.
Setting the time
Once the appliance has been connected to the mains
or after a power cut, the time flashes in the display. The
time starts at "12:00". Set the current time.
Requirement: The function selector must be set to the
off position.
1.
Use
or to set the time.
2.
Press
.
a The time that is set appears in the display.
Tip: You can define whether the time is shown in the
display in the basic settings → Page 17.
9 Operating the hotplate
You can find out everything you need to know about
operating your hotplate here.
9.1 Switching the hob on and off
▶
Switch the hob on and off using the main switch
If all of the cooking zones are switched off for
longer than 20 seconds, the hob is automatically
switched off.
reStart
▶
If you switch the appliance on within four seconds of
switching it off, the hob operates with the settings
that were previously set.
9.2 Setting the cooking zones
To choose the required selectable power level, touch
or
.
Each power level has an intermediate level. This is
marked with a dot.
Power level
Notes
¡ In order to protect the appliance's electronic parts
from overheating or surge currents, the hob may
temporarily reduce the power level.
Lowest power level
Highest power level
8.2 Cleaning the appliance before using it
for the first time
Clean the cooking compartment and accessories be-
fore using the appliance to prepare food for the first
time.
1.
Remove the accessory and the leftover packaging,
such as polystyrene pellets, from the cooking com-
partment.
2.
Before heating, wipe the smooth surfaces in the
cooking compartment with a soft, damp cloth.
3.
Ventilate the room while the appliance is heating.
4.
Set the type of heating and the temperature.
→ "Basic operation", Page 18
Type of heat-
ing
Temperature
Cooking time
5.
Switch off the appliance after the specified cooking
time.
6.
Wait until the cooking compartment has cooled
down.
7.
Clean the smooth surfaces with soapy water and a
dish cloth.
8.
Clean the accessory with soapy water and a dish
cloth or a soft brush.
¡ In order to prevent the appliance from producing ex-
cess noise, the hob may temporarily reduce the
power level.
Selecting the cooking zone and power setting
.
1.
Touch to select the cooking zone.
2.
Within the next 10 seconds, select the required
power level:
Touch to call up power level .
‒
Touch to call up power level .
‒
a The power level has been set.
Note: If no cookware is placed on the cooking zone or
the pot is not suitable, the selected power level flashes.
After a certain period of time, the cooking zone
switches itself off.
quickStart
▶
If you place cookware on the hob before you switch
it on, the cookware is detected when you switch on
and the corresponding cooking zone is selected
automatically. Select the power level in the next 20
seconds, or the hob switches itself off.
Changing the power level and switching off the
cooking zone
1.
Select the cooking zone.
2.
Touch
or
pears. To switch off the cooking zone, set .
Before using for the first time en
3D hot air
Maximum
1 hour
until the required power level ap-
15
Advertisement
Table of Contents
