Advertisement
3.WASH FUNCTION
(1) Water Plus is performed if the current water falls short of the selected water level by sensing the water level
setting, washing for 2 min and 9 min, turning the Motor OFF for 3 sec., then reading the water level
frequency, and the washing process goes on after proper water supply. The time for Water Plus does not
exceed Max. 30 seconds (for all course and water level).
* In case of rinse, economy wash and wool course, water plus is performed 1 min. later.
(2) Though the washing time is changed during in washing operation after performing the water plus function, it
does not perform the function anymore. Water plus is not performed when the water plus setting time has
passed.
2-3-2 RINSE PROCESS
1. DRAIN FUNCTION
(1) Drain function maintains the drain valve open ON.
If the water level at initial operation is higher than Reset, the drain function is performed for 50 seconds after
detecting Reset. If the water level at initial operation is lower than Reset, the drain function is performed for
20 seconds after detecting Reset.
(2) After starting the drain function, the remaining time starts counting down until the standard drain time
elapses, and stops counting down thereafter. If the drain function is completed, it is regarded as the
standard drain time is finished.
Water Level
High
Drain Time
2 min.10 sec
(3) If the water level is still higher than Reset when 5 min has passed after drain function is started, it performs
Drain Error function. Buzzer beeps 5 times and then enters the Pause mode.
(4) If the Start key is pressed in the above item (3), the Error status is cleared and Time Out is reset to 15min
again and then drain function resumes.
2.INTERMITTENT SPINNING
1) Opening the door while the Intermittent Spin is in operation stops spinning and generates Door Open Alarm
(Door Open Melody 5 times).
2) If the door is closed while the Door Open Alarm is ongoing, the alarm status is terminated and proceeds to
the next step in as identical order as in Start/Pause key-in.
3) If the Satefy S/W is sensed as Unbalance during the Intermittent Spinning cycle, it performs Unbalance Clear
function.
1. Unbalance Sensing Function
- S/W Sensing Time
UNBALANCE : 20~449mS, Door Open : 450mS or more.
If the Door is closed while the Door Open Alarm is undergoing, the alarm status becomes invalid and the
drain valve turns ON min. 10 seconds after OFF, and MOTOR resumes 10 seconds after the drain valve
turns ON.
2. Unbalance Clear Function
- It is the unbalance clear function which happens in spin process after finishing wash process.
It is the same working as adding spin course one more time.
After detecting the unbalance in rinse process and supplying the selected water it proceeds the
next rinse function.
When unbalance happens in the last spin process it gives the unbalance sound after preforming
the twice unbalance function.
- At the initial operation of this function (standard time of water supply + 1 min.) is added to the
remaining time of the corresponding process.
Release function performs discharging water after supplying water for 1 min.
- 'UE' turns ON/OFF for 1 sec. when unbalance error happens and gives flash melody 5 times.
- Release function performs its working when unbalance error happens during in spin only function
and it gives error sound when unbalance error happens twice times.
Middle
Low
2 min.
1 min.50 sec
Extra Low
Lowest
1 min.40 sec
1 min.30 sec 50 sec DELAY excluded
6
Remark
Advertisement
