Advertisement
(6) If Water Level is changed by pressing the Water Level key before Motor starts rotating, the water supplying
time also is changed according to the selected water level so the remaining time is recalculated.
(7) In the fuzzy course wash time can be changed only before motor starts rotating by using water level Wash
course performs its working by the previous set wash time regardless of water level after motor starts
rotating. (It proceeds to start wash course after supplying water up to the changed water level)
(8) Changing the wash times by using wash key calculates the selected time as the remaining times regardless
of the water level.
6.RESERVE KEY
(1) Reserve key-in is available only before entering start-key under the condition of pressing any course.
(2) Default value of the key as the repeated key is 3 hours.
(3) Each key-in can update 1 hour by pressing the key and max value of reserve times is 19 hours.
(4) After touching the key pressing the start key 3 hours is automatically reserved. Reserve time can be
changed only after pressing the start key in 10 min. Otherwise key-in is canceled.
(5) Manual wash time, rinse time and spin time can be adjusted only after pressing the start key in 10 min.
If total working time is over 3 hours automatic reserve process is canceled and return to the early condition.
2-3. MAIN FUNCTIONS
2-3-1 WASH COURSE
1. WATER SUPPLY
(1) The water supply function of each process opens the corresponding water valve ON until the selected water
level is fulfilled.
(2) Water supply valve for the water supply function of each process.
Selected Water
Wash
Cold Water
Cold Water
Hot/Cold Water
Hot/Cold Water
Hot Water
Hot Water
(3) Corresponding lamp flashes ON/OFF for 1 sec when water supply process is in operation and or OFF when
water supply process is not in operation.
(4) If the water supply is not completed yet after the standard time allocated for water supplying has passed, the
remaining time does not count down any more.
(5) If the water supply is already completed before the standard time allocated for water supplying has passed,
the remaining time counts down as much as the standard time and then proceed to next step.
(6) If the water supply is not completed even after 60 minutes has passed, Water Supply Error function is
performed.
(7) If a Water Level key is entered again after the water supply is all finished, and if the newly set level is higher
than the current level, then the water supply process is performed again, and the Motor is turned OFF and
the remaining time does not count down during water supply.
(8) Water supply times table for each water level.
Water level
High
Supply level
5 min
(9) If the water level comes down under the reset during in operation the process continues after the water is
supplied up to the selected water level.
2. SOAK COURSE
(1) The soak course is performed only when it is selected by using manual key.
(2) If the water is supplied up to the selected water level, soaking is repeatedly performed by 5 min.interval for
total 30 min. (Motor rotates for 1 min. and stops for 4 min.)
(3) If the water level is changed to a higher level while soaking is in operation, it stops soaking and starts water
supply, and then resume the soaking process(for all course and water level).
(4) Once the soaking is stopped and resumed again for any reason such as changed water level or Pause and
Re-start, the ongoing settings are still valid starting the soaking process from the breakpoint.
Rinse
Rinse2
Cold Water
Cold Water
Hot/Cold Water
Cold Water
Hot/Cold
Cold Water
Middle
4min, 30 sec
5
Water plus
Cold Water
Cold Water
Cold Water
Low
4 min
2min.30sec.
Intermittent spin
Cold Water
Cold Water
Cold Water
Extra low
Lowest
2min.
Advertisement
