Advertisement
6. HOW TO DISASSEMBLE
6-1 REPLACEMENT OF MAIN PCB-ASS'Y
1) After opening the right side lower part gap of
the COVER-PANEL in front of the CONTROL-PANEL
and the FRAME by using a coin or a key, disassemble
by pulling toward.
2) Remove 2 COVER-SCREW from the CONTROL-PANEL
by using a pin and then remove a SCREW 3EA as
shown in the figure.
3) Disassemble the CONTROL-PANEL by pushing it
slightly to left as shown in the figure here.
4) Turn the CONTROL-PANEL ASS'Y and remove
SCREW 5EA securing PCB ASS'Y.
5) Lift up the SCREW slightly to the disassembling
direction, it is disassembled.
6) Disconnect the CONNECTOR from ASS'Y PCB.
※ When disassembling CONTROL-PANEL, be careful not to
allow WIRE to get too much tension.
※ When assembling PCB, check if CONTROL-PANEL fixing
HOOK is properly positioned and tighten with screws.
(If not tightened exactly, Select S/W does not operate.)
※ Points to check after replacing PCB-ASS'Y
Check the each part operating status. (Using TEST MODE)
※ How to disassemble shutter
1) After removing from Hook by pulling down the fore of shutter,
and disassemble by pulling forward.
2) When assembling, push until making a sound how to use upward.
23
Advertisement
