CGTS NUV Instructions
Instructions for selecting CCT & lumen
1.
Two slide switches are located on the driver enclosure:
one for CCT and the other for lumen. CCT and lumen
options must be selected before installation.
2.
To select the CCT, slide the first switch to the desired
LED color temperature (3500K, 4000K, 5000K CCT).
3.
To select the lumen, slide the second switch to the
desired lumen pack.
Figure 1.
Wire Connection
L
N
Switch
Figure 2.
Installation Instruction
Warning
•
Don't install the panel light to an unstable ceiling or
near combustible materials.
Recessed In Plaster Or Grid Ceilings
Step 1: For installation into grid ceilings. Remove the
ceiling tile and then connect the panel light to an
incoming power line.
2
0-10V
L
N
LED Driver
LED
Panel
CGTS NUV Instructions
IB519150EN
Figure 3.
Step 2: Rotate the panel light by 45 degree and Pass the
panel through the ceiling surface.
Figure 4.
Step 3: Lay in the panel light on the ceiling surface or grid.
Figure 5.
Utilization of T-Grid Clips for Installation
Step 1: Pull T-grid clip away from panel until facing
perpendicular to the panel surface.
Figure 6.
www.cooperlighting.com