Bosch PSR 10,8 LI Original Instructions Manual page 36

OBJ_DOKU-26180-004.fm Page 36 Wednesday, August 20, 2014 11:55 AM
36 | English
Fully automatic spindle locking (Auto-lock)
When the On/Off switch 8 is not pressed, the drill spindle and thus the
tool holder are locked.
This enables screws to be screwed in, even when the battery is empty and
allows for the machine to be used as a screwdriver.
Run-on Brake
When the On/Off switch 8 is released, the chuck brakes to a stop, thus
preventing the run-on of the tool.
When driving in screws, wait until the screw is screwed in flush with the
material and then release the On/Off switch 8. By doing so, the head of
the screw does not penetrate into the material.
Battery Charge-control Indication
The battery charge-control indicator 5 indicates the charge condition of
the battery for a few seconds when the On/Off switch 8 is pressed half or
fully through. It consists of a three-colour illuminating LED.
LED
Continuous lighting, green
Continuous lighting, orange
Continuous lighting, red
Flashing light, red
Temperature Dependent Overload Protection
When using as intended for, the power tool cannot be subject to overload.
When the load is too high or the allowable battery temperature of 70 °C is
exceeded, the electronic control switches off the power tool until the tem-
perature is in the optimum temperature range again.
In case of overload, the battery charge-control indicator 5 additionally
flashes three times red and the "Power Light" 9 flashes three times white.
Protection Against Deep Discharging
The lithium-ion battery is protected against deep discharging by the "Elec-
tronic Cell Protection (ECP)". When the battery is empty, the machine is
switched off by means of a protective circuit: The inserted tool no longer
rotates.
1 609 92A 0UN | (20.8.14)
Capacity
≥ 66%
33—66%
11—33%
≤ 11%
Bosch Power Tools