Bosch PSR 10,8 LI Original Instructions Manual page 34

OBJ_DOKU-26180-004.fm Page 34 Wednesday, August 20, 2014 11:55 AM
34 | English
The power tool cannot be used during the charge procedure; it is not de-
fective when inoperative during the charging procedure.
Observe the notes for disposal.
Changing the Tool (see figure B)
 Before any work on the machine (e. g., maintenance, tool change,
etc.) as well as during transport and storage, set the rotational di-
rection switch to the centre position. Unintentional actuation of the
On/Off switch can lead to injuries.
The drill spindle is locked when the On/Off switch 8 is not pressed. This
makes quick, convenient and easy changing of the tool in the drill chuck
possible.
Open the keyless chuck 2 by turning in rotation direction , until the tool
can be inserted. Insert the tool.
Firmly tighten the collar of the keyless chuck 2 by hand in rotation direc-
tion  until the locking action ("click") is heard. This automatically locks
the chuck.
The locking is released again to remove the tool when the collar is turned
in the opposite direction.
Dust/Chip Extraction
 Dusts from materials such as lead-containing coatings, some wood
types, minerals and metal can be harmful to one's health. Touching or
breathing-in the dusts can cause allergic reactions and/or lead to res-
piratory infections of the user or bystanders.
Certain dusts, such as oak or beech dust, are considered as carcino-
genic, especially in connection with wood-treatment additives (chro-
mate, wood preservative). Materials containing asbestos may only be
worked by specialists.
– Provide for good ventilation of the working place.
– It is recommended to wear a P2 filter-class respirator.
Observe the relevant regulations in your country for the materials to be
worked.
 Prevent dust accumulation at the workplace. Dusts can easily ignite.
1 609 92A 0UN | (20.8.14) Bosch Power Tools