Parts Of The Machine; Commissioning; Settings; Tool Holder, Attachments - Festool DWC 18-2500 Original Instructions Manual

Cordless drywall screwdrivers
Max. workable screw length
Weight (incl. battery pack and magazine attachment)
as per EPTA procedure 01:2014
Weight excl. battery pack
Weight excl. battery pack, incl. depth stop
Weight excl. battery pack, incl. magazine attachment
* Speed values based on fully charged battery
pack.
5

Parts of the machine

[1-1] Bit store
[1-2] On/off switch
[1-3] Rotational direction switch
[1-4] AUTO/MAN selector switch
[1-5] Depth stop
[1-6] Bits
[1-7] Insulated gripping surfaces (grey sha­
ded area)
[1-8] Capacity display button on battery pack
[1-9] Capacity display
Accessories shown or described are not always
included in the scope of delivery.
The specified illustrations appear at the begin­
ning of the Operating Instructions.
6

Commissioning

6.1 Changing the battery pack
Inserting the battery pack [2 A]
Removing the battery pack [2 B]
The battery pack is ready to use straight out of
the box and can be charged at any time.
6.2 Changing the battery pack
Inserting the battery pack [2 A]
Removing the battery pack [2 B]
The battery pack is ready to use straight out of
the box and can be charged at any time.
Further information about the battery
pack and charger can be found in the
corresponding operating manual.
DWC 18-2500
55 mm
7

Settings

CAUTION
Risk of injury
► Only adjust the settings when the power
tool is switched off.
7.1 Changing direction of rotation [1-3]
– Switch to the left = clockwise rotation
– Switch to the right = counterclockwise rota­
tion
8

Tool holder, attachments

WARNING
Risk of injury, electric shock
► Always disconnect the battery pack before
any type of work on the machine!
8.1 Bit holder
The bit holder enables the operator to change
drill bits quickly.
CAUTION
Risk of injury from hot and sharp tool
► Do not use any blunt or faulty tools.
► Wear protective gloves.
Attaching the bit holder
► Move the switch [1-4] to the MAN position.
► Push the bit holder [3-2] into the tool hold­
er [3-4] until it clicks into place.
► Place the bit [3-3] in the holder.
► Then affix the depth stop to the transmis­
sion housing, as described in section .
Removing the bit holder
► Take out the depth stop as described in sec­
tion .
► Remove the bit holder from the tool holder
by pulling firmly.
8.2 Changing the bit
To change the bit [1-6], you can use the depth
stop [1-5].
English
DWC 18-4500
55 mm
2 kg
1.2 kg
1.3 kg
1.6 kg
15