First Use; Programming Via Manufacturer's Code; Programming Via Automatic Scan - Silvercrest SFS 18 A1 User Manual And Service Information

SilverCrest SFS 18 A1

First use

To be able to use the remote control, you must first perform
one of the following steps.

Programming via manufacturer's code

1. On the remote control, select the device (A or B) which
you want to programme.
2. In the code list attached to these operating instructions,
find the appropriate 4-digit code for your device (e.g.
TARGA 1268) from the relevant device group (e.g. TV).
3. Press and hold the selected device button, for example,
"A" (6), for approx. 3 seconds. Once the blue LED (4)
lights up continuously, release the button. The remote
control is now in programming mode for approx. 10
seconds. If no entries are made within 10 seconds, the
programming mode is cancelled automatically.
4. Now, enter the 4-digit device code using the number
buttons (12). If the remote control accepts the code
which was entered, the blue LED (4) goes out. The code
is invalid if the LED (4) flashes twice. In this case, the
remote control remains in programming mode. Enter a
correct code within 10 seconds.
5. After entering the code, check whether the buttons on
your remote control work correctly. If the remote control
does not work correctly, try another 4-digit device code
of the same manufacturer (e.g. TARGA 1276). Repeat
steps 3 to 5 until the remote control works correctly.

Programming via automatic scan

1. The device that you want to use must be switched on.
2. Point the remote control at the device. Press and hold
the selected device button, for example, "A" (6), for
approx. 5 seconds. Once the blue LED (4) flashes, the
remote control is in automatic search mode.
3. The "VOL+" signal is now continuously sent to your
device (code scanning function). Once the volume of
your device changes, press the device button "A" (6)
immediately to stop the automatic search mode.
4. If your device is a CD player, a tuner or a cassette
player, rather than a TV, a POWER signal is
continuously sent to the device. Once your device is
70 - English