Replacing Sdram Dimms; Required Tools And Equipment; Sdram Dimm Replacement - Cisco AS5350 Installation Manual

Appendix

Replacing SDRAM DIMMs

This section describes how to replace SDRAM DIMMs on the system board. You might need to upgrade
the SDRAM DIMMs for the following reasons:
•
•
The system board contains three sockets for SDRAM DIMMs (see Figure A-3):
•
•

Required Tools and Equipment

You need the following tools and equipment:
•
•

SDRAM DIMM Replacement

To replace the SDRAMM, follow this procedure:
Step 1 Turn the power switch on the universal gateway off and disconnect site power.
Step 2 Remove all interface cables from the rear panel of the universal gateway.
Warning Before opening the chassis, disconnect the telephone-network cables to avoid contact with
telephone-network voltages. To see translations of the warnings that appear in this publication, refer
to the Regulatory Compliance and Safety Information document that accompanied this device.
Attach an ESD-preventive wrist strap.
Step 3
Remove the chassis cover. (See the instructions in the "Removing the Chassis Cover" section on
Step 4
page A1.)
Use Figure A-3 to locate the DIMM you are replacing.
Step 5
78-10754-03 0A
You have upgraded to a new Cisco IOS feature set or release that requires more memory.
You are using very large routing tables or many protocols (for example, when the universal gateway
is set up as a connection device between large external networks and your internal network).
Two sockets hold main memory SDRAM DIMMs. Main memory is used by the CPU to store the
operating configuration, routing tables, and queues. The DIMMs can be 128 or 256 MB, and the
capacity of the DIMMs in both sockets must match.
For main memory, the total capacity is 512 MB (two, 256 MB DIMMs).
–
One socket holds a shared memory SDRAM DIMM. Shared memory is used to store incoming and
outgoing packets. This DIMM can be 64 or 128 MB.
For shared memory, the total capacity is 128 MB (one, 128 MB DIMM).
–
ESD-preventive wrist strap
The appropriate SDRAM DIMM(s) for your universal gateway
Cisco AS5350 Universal Gateway Chassis Installation Guide
Replacing SDRAM DIMMs
-7