Removing The Old Power Supply - Cisco AS5350 Installation Manual

Removing the Old Power Supply

Removing the Old Power Supply

This section describes how to remove the power supply. Note the following safety warnings before you
remove the power supply:
Ultimate disposal of this product should be handled according to all national laws and regulations.
Warning
To see translations of the warnings that appear in this publication, refer to the Regulatory Compliance
and Safety Information document that accompanied this device.
Warning Only trained and qualified personnel should be allowed to install or replace this equipment. To see
translations of the warnings that appear in this publication, refer to the Regulatory Compliance and
Safety Information document that accompanied this device.
Read the installation instructions before you connect the system to its power source. To see
Warning
translations of the warnings that appear in this publication, refer to the Regulatory Compliance and
Safety Information document that accompanied this device.
Before working on a system that has an on/off switch, turn OFF the power and unplug the power cord.
Warning
To see translations of the warnings that appear in this publication, refer to the Regulatory Compliance
and Safety Information document that accompanied this device.
Warning Before working on equipment that is connected to power lines, remove jewelry (including rings,
necklaces, and watches). Metal objects will heat up when connected to power and ground and can
cause serious burns or weld the metal object to the terminals. To see translations of the warnings that
appear in this publication, refer to the Regulatory Compliance and Safety Information document that
accompanied this device.
To remove the power supply, follow this procedure:
Step 1 Place the universal gateway so that the rear panel is facing you.
Step 2 Remove the mounting screw that secures the power supply to the chassis and set it aside. (See Figure B-5
or Figure B-6.)
Note
Cisco AS5350 Universal Gateway Chassis Installation Guide
-6
Although the following illustrations show only the AC power supply, the procedures are the
same for the DC power supply.
Appendix
78-10754-03 0A