Chapter 2 Preparing To Install The Cisco As5350 Chassis; Safety Recommendations; Maintaining Safety With Electricity - Cisco AS5350 Installation Manual

Preparing to Install the Cisco AS5350 Chassis
This chapter describes the tasks you must perform before you begin to install the Cisco AS5350 and
includes the following sections:
•
•
•

Safety Recommendations

Any device that uses electricity must be handled carefully; follow these guidelines to ensure general
safety:
•
•
•
•
•
•
Warning Ultimate disposal of this product should be handled according to all national laws and regulations.
To see translations of the warnings that appear in the publication, refer to the Regulatory Compliance
and Safety Information document that accompanied this device.

Maintaining Safety with Electricity

Before working on equipment that is connected to power lines, remove jewelry (including rings,
Warning
necklaces, and watches). Metal objects will heat up when connected to power and ground and can
cause serious burns or can weld the metal object to the terminals. To see translations of the warnings
that appear in the publication, refer to the Regulatory Compliance and Safety Information document
that accompanied this device.
78-10754-03 0A
Safety Recommendations, page 2-1
Required Tools and Equipment, page 2-3
Preparing to Connect to a Network, page 2-3
Keep the chassis area clear and dust-free during and after installation.
Put the removed chassis cover in a safe place.
Keep tools away from walk areas where you and others could fall over them.
Do not wear loose clothing that could get caught in the chassis. Fasten your tie or scarf and roll up
your sleeves.
Wear safety glasses if you are working under any conditions that might be hazardous to your eyes.
Do not perform any action that creates a potential hazard to people or makes the equipment unsafe.
C H A P T E R
Cisco AS5350 Universal Gateway Chassis Installation Guide
2
2-1