Connecting T1 Cas Telephony Cables For A Cisco Unified Meetingplace 8106 - Cisco 700 MHz Installation And Upgrade Manual

Connecting the Cables to the Cisco Unified MeetingPlace 8100 Series
Plug the other end of the LAN cable into Ethernet connection 1 on the CPU transition module that is
Step 3
located in the back of the Cisco Unified MeetingPlace Audio Server.

Connecting T1 CAS Telephony Cables for a Cisco Unified MeetingPlace 8106

Each T1 Smart Blade transition module has connectors for four trunk lines in the back of the Cisco
Unified MeetingPlace Audio Server.
Looking at the back of the Cisco Unified MeetingPlace 8106, the T1 Smart Blade transition modules
begin in slot 1 on the bottom and move up to the top. The cables go from right to left on the bottom slot,
then from right to left on the second most bottom slot, and so on up to the top slot, where they continue
going from right to left.
Table 2-1
Table 2-1
Slot 6
Slot 5
Slot 4
Slot 3
Slot 2
Slot 1
The number of T1 CAS telephony cables that Cisco Systems ships with the Cisco Unified MeetingPlace
system depends on the number of ports being activated. Cisco Systems ships one T1 CAS telephony
cable for every 24 ports.
Figure 2-8
Four T1 CAS telephony cables connect to each of the six T1 Smart Blade transition modules for a total
of 24 T1 CAS telephony cables. Each cable holds 24 ports for a total of 576 ports (24 x 24 = 576).
Figure 2-8
Installation and Upgrade Guide for Cisco Unified MeetingPlace Audio Server 6.x
2-12
shows the order in which the cables should be placed.
Cable Locations in the Cisco Unified MeetingPlace 8106
Connector Connector
24 23
20 19
16 15
12 11
8 7
4 3
shows the cable connections for a Cisco Unified MeetingPlace 8106 with 576 T1 CAS ports.
Back of Cisco Unified MeetingPlace 8106 with T1s Connected
Chapter 2 Installing the Cisco Unified MeetingPlace 8100 Series Hardware
Connector Connector
22 21
18 17
14 13
10 9
6 5
2 1
OL-13417-01