Connecting The Power Cable To The Cisco Unified Meetingplace 8100 Series; Connecting The Scsi Cable To The Cisco Unified Meetingplace 8112; Connecting The Lan Cable To The Cisco Unified Meetingplace 8100 Series - Cisco 700 MHz Installation And Upgrade Manual

Chapter 2 Installing the Cisco Unified MeetingPlace 8100 Series Hardware

Connecting the Power Cable to the Cisco Unified MeetingPlace 8100 Series

This equipment must be grounded. Never defeat the ground conductor or operate the equipment in the
Warning
absence of a suitably installed ground conductor. Contact the appropriate electrical inspection
authority or an electrician if you are uncertain that suitable grounding is available. Statement 1024
When installing or replacing the unit, the ground connection must always be made first and
Warning
disconnected last. Statement 1046
To Connect the Power Cable to the Cisco Unified MeetingPlace 8100 Series
Step 1 Locate the power cable that shipped with the Cisco Unified MeetingPlace Audio Server.
Step 2 Attach the socket end of the power cable to the AC inlet on the back of the Cisco Unified MeetingPlace
Audio Server.
Step 3 Plug the other end of the power cable into the AC power source.

Connecting the SCSI Cable to the Cisco Unified MeetingPlace 8112

Note The Cisco Unified MeetingPlace 8106 does not have a SCSI cable.
To Connect the SCSI Cable to the Cisco Unified MeetingPlace 8112
Confirm that the power switch on the Cisco Unified MeetingPlace 8112 is set to off ("O").
Step 1
Attach one end of the SCSI cable that came with the Cisco Unified MeetingPlace Audio Server system
Step 2
to the SCSI connector on the back of the floppy-drive housing.
Attach the other end of the SCSI cable to the SCSI port on the CPU transition module in slot 7 on the
Step 3
back of the Cisco Unified MeetingPlace 8112.

Connecting the LAN Cable to the Cisco Unified MeetingPlace 8100 Series

You must supply the LAN cable to connect the Cisco Unified MeetingPlace Audio Server to the network.
See the
that you have the correct LAN cable and connector.
To Connect the LAN Cable to the Cisco Unified MeetingPlace 8100 Series
Step 1 Locate the LAN cable.
Step 2 Plug one end of the LAN cable into the LAN socket.
OL-13417-01
"LAN Requirements for Cisco Unified MeetingPlace Systems" section on page 1-12
Installation and Upgrade Guide for Cisco Unified MeetingPlace Audio Server 6.x
Connecting the Cables to the Cisco Unified MeetingPlace 8100 Series
to confirm
2-11