E1 Digital Trunk Requirements For Cisco Unified Meetingplace Systems; E1-Supported Protocols For Cisco Unified Meetingplace Systems - Cisco 700 MHz Installation And Upgrade Manual

E1 Digital Trunk Requirements for Cisco Unified MeetingPlace Systems

E1 Digital Trunk Requirements for Cisco Unified MeetingPlace
Systems
Confirm that the E1 digital trunk specifications meet the requirements in
Table 1-6
Country
European Union
Australia
In some cases, the RJ-48c cables that Cisco Systems provides may not be appropriate for your PBX or
NIU-side connections. If this is the case, create your own custom cables. Custom E1 and T1 PRI cables
require the following:
•
•
•
Note In E1 Cisco Unified MeetingPlace systems, you can connect Cisco Unified MeetingPlace directly to the
PSTN. You do not need a CSU.
E1-Supported Protocols for Cisco Unified MeetingPlace
Systems
The following protocols are supported for E1 digital trunks:
•
•
•
The Cisco Unified MeetingPlace system supports only E1 PRI protocols. The Cisco Unified
MeetingPlace system does not support E1 CAS protocols.
Figure 1-3
Installation and Upgrade Guide for Cisco Unified MeetingPlace Audio Server 6.x
1-10
E1 Digital Trunk Requirements
Requirements
Connection Type—Euro ISDN and QSIG digital telephony (E1).
Cable supplied by Cisco Systems—25-foot Cat5 cable with RJ-48c connectors at
each end.
Socket—Connector must be an RJ-25 socket or an NBNC (female) connector.
Cable length (if you provide your own cable)—Maximum cable length is 328 feet.
Cisco Systems does not supply any E1 cables with Cisco Unified MeetingPlace
Audio Server systems that are shipped to Australia.
Cat5e UTP cable.
RJ-48c connector on the breakout box side.
Add the ferrite that is on the cable that is supplied by Cisco Systems.
Euro-ISDN (ETSI 300-102).
QSIG (ECMA version)—Channels are numbered 1 to 30.
QSIG (ETSI version)—Channels are numbered 1 to 15 and 17 to 31.
illustrates the Cisco Unified MeetingPlace digital telephony connections with E1 trunks.
Chapter 1 Preparing to Install the Cisco Unified MeetingPlace 8100 Series Hardware
Table 1-6.
OL-13417-01