Step 6. Configure The Card With Network Parameters Required For Your Network - HP Jetdirect 610n Hardware Installation Manual

Step 6. Configure the Card with
Network Parameters Required for
Your Network
If the card has been successfully installed and is operating correctly,
you are now ready to configure the card for network operation. You
can configure the card using the following methods:
Use the installation and configuration software on the
HP Jetdirect CD-ROM.
On Microsoft Windows 95/98/Me/NT/2000/XP systems
(Microsoft or Novell NetWare networks), use the Install
Network Printer wizard. This wizard will allow you to
configure the required network parameters on the print
server, and will also install the printer on your system.
On HP-UX and Sun Solaris systems, use the HP Jetdirect
Printer Installer for UNIX in the UNIX subdirectory. For
instructions, read the release notes and documentation
provided with the software.
Use a web browser to access the embedded web server on the HP
Jetdirect print server. The web pages on the print server allow
you to configure network parameters. For more information, see
the applicable HP Jetdirect Administrator's Guide on the HP
Jetdirect CD-ROM
Use the printer's control panel (for printers with a supported
control panel) to configure basic network parameters on the card.
See HP Jetdirect EIO Menu
For TCP/IP networks, use an advanced configuration method,
such as BootP, DHCP, Telnet, or the "arp" and "ping" commands.
For instructions, see the appplicable HP Jetdirect
Administrator's Guide included on the HP Jetdirect CD-ROM.
Use HP printer management software (such as HP Web
JetAdmin) or other network utilities to configure network
parameters. HP printer management software can be
downloaded from HP's Customer Care Online at:
http://www.hp.com/support/net_printing
ENWW
in Appendix A for more information.
Installing the Print Server 2-21