Connecting A Server, Pc, Or Workstation - Cisco 802 Installation And Configuration Manual

Connecting Cables to the Router

Connecting a Server, PC, or Workstation

TO HU B
TO PC
Connect the yellow cable to one of the following ports:
•
•
Step 1 Connect the other end of the cable to the server, PC, or workstation.
Step 2 Check the LED corresponding to the connected port after router power-up:
•
•
If the LINK or ETHERNET 1 LED is not on, try pressing the TO HUB/TO PC button.
Step 3
If the ETHERNET 2, 3, or 4 LED is not on, see the Cisco 800 Series Routers Hardware Installation
Step 4
Guide.
Installing and Configuring Cisco 802 IDSL and Cisco 804 IDSL Routers
8
C is co 80 4
ET HE RN
ET 10 BA
ID SL
SE T
CO NS OL
E
ID SL
1
2
3
4
Cisco 804 IDSL Router
The yellow Ethernet port on your Cisco 802 IDSL router.
Any of the yellow Ethernet ports on your Cisco 804 IDSL router.
The LINK LED is on the Cisco 802 IDSL back panel.
ETHERNET 1, 2, 3, and 4 LEDs are on the Cisco 804 IDSL front panel.
+5 , -2 4,
-7 1 VD C
PC
78-10368-03