Windsor Pivot Manual page 6

Pour in water/detergent mixture.
Maximum temperature of the liquid
122°F (50°C).
Close the cover of the fresh water
reservoir.
Driving to the Place of Use
Place the push handle vertically and
lock.
Insert the transport wheel axles into
the borings on the machine and lock
them.
Tilt the machine to the side and
drive it to the place of use on its
transport wheels.
At the site of use:
Press the transport wheel release
button and pull the transport wheel
out.
Insert the transport wheels into their
holder until they stop.
Establish mains contact
Danger
Check the cords on the machine each
time before using the machine to see
that it is not damaged. Never operate
a machine with damaged cables. Get
the damaged cables replaced by an
electrician.
Insert the looped end of the exten-
sion cable in the strain relief hook.
Plug in machine.
6
English
Cleaning method
Move the machine back and forth.
Place the push handle vertically and
lock.
Push the push handle down and
turn it to the position indicated
above.
Start up the machine (see "Clean-
ing") and move it forward and back-
wards over the surface to be
processed.
Move the machine from side to side
Place the push handle vertically and
lock.
Push the push handle down and
turn it to the position indicated
above.
Start the machine up (see "Clea-
ing".
Move the machine to the left:
Press the left side of the push han-
dle down.
Move the machine to the right::
Press the rlght side of the push han-
dle down.
Cleaning
Slide the lock of the push handle up
and swivel it to a comfortable work-
ing height.
Turn on the brushes by using the
switch for the brush drive.
Turn on the brush irrigation by using
the switch for the detergent solu-
tion.
Move the machine over the surface
to be processed by the push handle
(see "Cleaning method").
Warning!
Risk of damage to the floor covering.
Do not operate the machine on the
spot.
Polishing
Slide the lock of the push handle up
and swivel it to a comfortable work-
ing height.
Turn on the brushes by using the
switch for the brush drive.
Move the machine over the surface
to be processed by the push handle
(see "Cleaning method").
Warning!
Risk of damage to the floor covering.
Do not operate the machine on the
spot.
Note
To polish underneath furniture, the
fresh water reservoir can be removed.
Shutting Down the Machine
Release the switch for detergent so-
lution.
Release the brush drive button.
Place the push handle vertically and
arrest.
Disconnect the plug.
Emptying the Solution tank
Lift up the fresh water reservoir and
carry it to the disposal site.
Warning
Please observe the local provisions re-
garding the wastewater treatment.
Remove the cover of the fresh wa-
ter reservoir and pour out the liquid
via the notch.
Transport
If you want to transport the machine
on a vehicle secure it from slipping.
To reduce the required space, the
pushing handle can be folded or disas-
sembled:
Release the star grips of the push-
ing handle fastening.
Unscrew the star grips, remove the
screws and take off the upper push
handle half.
Storing the machine
Push the push handle lock up and
swivel the push handle down over
the machine toward the fresh water
reservoir and lock it.