Installing The Cisco Unified Videoconferencing 3545 Gateway; Physical Description; Gateway Module - Cisco 545 Serial Installation And Upgrade Manual

Installing the Cisco Unified
Videoconferencing 3545 Gateway
This section describes the following topics:
•
•
•
•
•
•
•
•
•
•
•
•
•

Physical Description

This section provides a physical description of the gateway modules and their corresponding RTMs.

Gateway Module

The gateway module has a 10/100BaseT Ethernet port on the front panel that uses an RJ-45 connector
to connect to the network. There is an asynchronous, 9-pin serial port that you can use with a
hyperterminal program to configure and monitor the module.
Figure 2-1
components.
Installation and Upgrade Guide for Cisco Unified Videoconferencing 3545 PRI Gateway and 3545 Serial Gateway Release 5.5
OL-14912-01
Physical Description, page 2-1
Preparing for Installation, page 2-3
Verifying the Package Contents, page 2-4
Mounting the Cisco Unified Videoconferencing 3545 Chassis in a 19-inch Rack, page 2-5
Installing the Gateway, page 2-6
Initial Gateway Configuration, page 2-10
Connecting the Gateway to the Network, page 2-14
Connecting PRI Lines to the Gateway, page 2-14
Connecting Serial Lines to the Gateway, page 2-14
Serial Gateway Cable Connections and Pin-outs, page 2-15
Connecting the Gateway to a Power Source, page 2-27
Accessing the Gateway Administrator Interface, page 2-27
Registering the Online Help, page 2-28
shows the front panel components of the gateway module.
C H A P T E R
Table 2-1
2
describes these
2-1