Warnings And Important Information; Safety And Regulatory Information - Rinnai ENDURO SP200B Operation & Installation Manual

WARNINGS AND IMPORTANT INFORMATION

SAFETY AND REGULATORY INFORMATION

DO NOT operate this system before reading the manufacturers instructions.
This appliance must be installed, commissioned and serviced by an authorised person in
WARNING
accordance with all applicable local rules and regulations.
Access covers of water heating system components will expose 240V wiring and MUST be
removed by an authorised person.
This appliance is not intended for use by persons (including children) with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless they have been
given supervision or instruction in use of the appliance by a person responsible for their safety.
For continued safety of this appliance it must be installed, operated and maintained in accordance
with the manufacturer's instructions.
Children should be supervised to ensure they DO NOT play with the appliance.
Any power leads from the water heater system components MUST BE plugged into an external
weatherproof electrical outlet. If the power supply cord of any water heating components is
damaged, it MUST BE replaced by an authorised person in order to avoid a hazard, using genuine
replacement parts available from Rinnai. Take care not to touch power plugs with wet hands.
Care should be taken not to touch the pipe work as it may be HOT! The pipes between the
solar collectors and storage cylinder MUST BE copper or alternative material pipes that may be
supplied by Rinnai. Plastic pipe is NOT suited to the water temperatures and pressures that may
occur in the system.
DO NOT place articles on or against this appliance.
DO NOT store chemicals or flammable materials near this appliance.
DO NOT operate with collectors or covers removed from this appliance.
DO NOT activate pump unless cylinder is full of water.
NEVER use a flammable spray such as hair spray, lacquer, paint, etc near this unit as this may
cause a fire.
NOTICE TO VICTORIAN CONSUMERS
This appliance must be installed by a person licensed with the Victorian Building Authority.
WARNING
Only a licensed person will have insurance protecting their workmanship.
So make sure you use a licensed person to install this appliance and ask for your Compliance
Certificate. For Further information contact the Victorian Building Authority on 1300 815 127.
Rinnai 4 DD FP Solar Pre Heat System OIM