Table of Contents
Advertisement
COLLECTOR MOUNTING RAIL PRE ASSEMBLY
This type of installation is not suitable for use in cyclonic areas.
WARNING
•
For a three collector installation join the 2.1 and 1.0 m rails using the joining plate and 4 of the M6 nut, bolt
and washers.
•
Assemble the collector rail components as shown in the diagrams below.
•
Loosely attach the clamping brackets using the M6 nuts, bolts and washers.
•
If the collectors are to be mounted to a tiled roof, fasten the collector support straps (supplied with the
collectors) using the M8 nut, bolt and washers.
When installing on a roof above 10 metres in height, the short clamping brackets are not used, and must be
replaced with 900mm clamping brackets that are supplied in DDHRKIT2 and DDHRKIT3. The "Installation Manual
- Rinnai Commercial High Rise Kit" (15401104) that is provided in these kits must be followed as well as this
instruction.
If a flat roof frame is used on an installation above 10 meters in height then the frame must be mounted to the roof
in accordance with the "High Rise Roof Mounting Frame Installation Instruction" (15401103).
Rinnai
INSTALLATION - SOLAR COLLECTORS
15
DD FP Solar Pre Heat System OIM
Advertisement
Table of Contents
