Function Selection Mode; Default Setting - SMC Networks ZSE20B-L Operation Manual

Function Selection Mode

■Function selection mode
In measurement mode, press the
the function to be changed [F□□]. Press and hold the
selection mode to return to measurement mode.
∗: Some products do not have all the functions. If no function is available or selected due to configuration of other functions, [- - -] is
displayed on the sub display (right).

■Default setting

The default setting is as follows.
If no problem is caused by this setting, keep these settings.
To change a setting, enter function selection mode.
●[F 0] Display units, switch output specifications and diagnostic information selection function
Units specification
"Nil" or M
P
Item
Switch output specifications
Diagnostic information
button between 3 and 5 seconds, to display [F 0]. Select to display
Pressure range Default setting
ISE20B MPa
ZSE20B(F)
kPa
ISE20B
ZSE20B(F)
Default setting
PNP
ALL
button for 2 seconds or longer in function
psi
-28-
Page 30
No.PS※※-OMV0006-D