F 1 Setting Of Out1 - SMC Networks ZSE20B-L Operation Manual

■[F 1] Setting of OUT1
Set the output mode of OUT1.
Output turns on when the pressure is greater than the set value. The default setting is to turn on the
pressure switch when the pressure reaches the center of the atmospheric pressure and upper limit of the
rated pressure range.
The display color changes according to the OUT1 output status. It will turn Green when the output is ON and
it will be Red when the output is OFF.
Please refer to the "List of output modes" on page
<Operation>
Press the or
Output mode setting
Press the or
Press the button to set.
Reversed output setting
Press the or
select the reversed output.
Press the button to set.
Pressure setting
Set the pressure based on the
setting method on page 24.
Hysteresis mode: [P_1]
Window comparator mode: [P1L] [P1H]
"P" is changed to "n" as [P_1] → [n_1] when
reversed output is selected.
The snap shot function can be used.
(Refer to page 58.)
Press the button to set.
34
button in function selection mode to display [F 1].
Press the button.
button to select the required output mode.
Move on to reversed output setting.
button to
Move on to pressure setting.
Move on to hysteresis setting.
for the relationship between the set items and operation.
Move on to output mode setting.
[Err] Error output is
selected
Press the button
to move on to display
color setting.
-32-
[OFF] Output off is
selected
Press the
button to move on to
display color setting.
No.PS※※-OMV0006-D