HP xw8400 Service And Technical Reference Manual page 133

Table 5-18 POST error messages (continued)
Screen Message
214–DIMM Configuration
Warning.
301–Keyboard Error.
303–Keyboard Controller
Error.
304–Keyboard or System Unit
Error.
401–Parallel Port 1 Address
Assignment Conflict.
404–Parallel Port Address
Conflict Detected.
410–Audio Interrupt Conflict.
411–Network Interface Card
Interrupt Conflict.
501–Display Adapter Failure.
510–Splash Screen image
corrupted.
511–CPU Fan not detected.
512–Chassis fan not detected. Fan is not connected or it might have
ENWW
Probable Cause
DIMMs not installed correctly (not
paired correctly).
Keyboard failure.
I/O board keyboard controller.
Keyboard failure.
IRQ address conflicts with another
device.
Both external and internal ports are
assigned to parallel port X.
IRQ address conflicts with another
device.
IRQ address conflicts with another
device.
Graphics display controller.
Splash Screen image has errors.
Fan is not connected or it might have
malfunctioned.
malfunctioned.
Recommended Action
Refer to Memory on page 65"Memory" for the correct
memory configurations and reseat the DIMMs
accordingly.
1. Reconnect keyboard with workstation
powered off.
2. Check the connector for bent or missing pins.
3. Be sure that none of the keys are pressed.
4. Replace keyboard.
1. Reconnect keyboard with workstation
powered off.
2. Replace the system board.
1. Reconnect the keyboard with workstation
powered off.
2. Be sure that none of the keys are pressed.
3. Replace keyboard.
4. Replace system board.
Reset the IRQ in the BIOS Setup menu.
1. Remove any parallel expansion cards.
2. Clear CMOS.
3. Reconfigure card resources and run Computer
Setup (F10 Setup).
Reset the IRQ in the BIOS Setup menu.
Reset the IRQ in the BIOS Setup menu.
1. Reseat the graphics card (if applicable).
2. Clear CMOS.
3. Verify that the monitor is attached and turned on.
Install latest version of ROMPaq to restore image.
1. Reseat fan cable.
2. Reseat the fan.
3. Replace the fan.
1. Reseat chassis or rear chassis fan cable.
2. Reseat chassis, rear chassis, or front chassis fan.
3. Replace chassis, rear chassis, or front
chassis fan.
POST error messages 125