HP Xw6400 - Workstation - 4 GB RAM Installation Manual

This document describes how to install the internal USB cable for your HP Workstation.

Kit Contents

This kit includes the following components:
■ Internal USB cable
■ Adjustable cable strap
■ Warranty
■ Internal USB cable instruction (this document)

Observe Warnings and Cautions

Å WARNING: Any surface or area of the equipment marked with this symbol indicates the presences of a hot
surface or hot component. If this surface is contacted, the potential for injury exists. To reduce the risk of
injury from a hot component, allow the surface to cool before touching.
Å WARNING: Any surface or area of the equipment marked with this symbol indicates the presence of an
electrical shock hazard. To reduce the risk of injury from electrical shock, do not open any enclosed area.
Ä CAUTION: Static electricity can damage the electronic components of the workstation. Before beginning
these procedures, be sure you are discharged of static electricity by briefly touching a grounded metal
object.
Step 1—Prepare the Workstation
Your workstation documentation includes instructions for disassembling and preparing the workstation for
installation, including shutting down power, disconnecting all power from the system, and removing the
access panel. For more detailed information, refer to the Service and Technical Reference Guide for your
HP Workstation at http://www.hp.com/support/workstation_manuals.
1/4
Internal USB Cable
HP xw Series Workstations
Internal USB Cable Installation