Pre-Operation Check; Switching On And Off - IVT TC-900 Instruction Manual

The tile cutter is equipped with a function for
cutting angle adjustment.
To change the cutting angle, simply unscrew the
two cutting angle adjusting knobs (4) which are
situated underneath each side of the machine.
Adjust the work table (9) at the desired cutting
angle (to know the exact cutting angle, refer to the
graduated bar (12)).
NOTE: For high precision works, it is better to do a
trial cut on a useless or unusable piece of tile.
Oblique cut – using the angle gauge (7)
fig.7
7
8
To make cuts at 45 ° thanks to the angle gauge (7),
place the angle gauge (7) against the parallel guide.
Loose the clamping knobs and position the parallel
guide (8) according to the desired cutting width.

Pre-operation check

Before using the tile cutter, run the device with no
load for 1 minute.
Check that all parts rotate properly without
abnormal noise and watch out if there are sparks.
If any sparks occur, quickly switch-off the machine.

Switching on and off

Before connecting the device to the electric power
supply, make sure that the main supply voltage
is 230V/50Hz and being suitable for use only in
premises having a service current capacity equal
to or greater than 100A per phase with a normal
voltage of 400/230V.
To start the tile cutter, position the on/off switch (5)
on the start position, (push the green button).
To turn it off, set the on/off switch (5) to the stop
position by pressing the red button.
fig.8
IMPORTANT: Check regularly the water
level in tank (3).
IMPORTANT: Make sure the rate of
introduction of the tile is adapted to the
cutting capacity of the blade (2). This
prevents the projection of pieces of tiles and
avoids any risk of injury.
ATTENTION! Do not force the machine.
Manteinance and storage
• Before carrying out any maintenance operation,
turn off the electric power supply by disconnecting
the plug from the extension cable.
• Always keep the machine and the ventilation
slots cleaned. If the machine should fail despite the
rigorous manufacturing and testing procedures, the
repair should be carried out by an authorized IVT
customer service.
• Regular cleaning and maintenance of the
appliance will ensure efficiency and prolong the life
of your appliance.
• Keep all nuts, bolts, and screws tight, to be sure
the appliance is in safe working condition.
• Replace worn or damaged parts for safety.
• Store the appliance in a dry room out of reach of
kids and away from any flammable material.
• Never wet the machine or spray water on it!
• Before any operation of maintenance or cleaning,
make sure the machine is disconnected from the plug.
The defective parts must be replaced with original
parts.
The replacement of the plug or power cord must
13
Manual instruction
5
EN