Default Scsi Ids - HP Visualize b132L Service Handbook

Configuration
FRU Configurations
Table 6 lists the recommended SCSI IDs for internal
storage devices.
NOTE: There are no jumper settings to change for the floppy drive.
These SCSI IDs are the default IDs for each storage
device. If an existing device already uses an ID, select
an alternate ID.
Table 6

Default SCSI IDs

Fast, Wide SCSI
1st Hard Disk Drive
2nd Hard Disk Drive
Note: The Fast, Wide SCSI controller is set to
Single-Ended SCSI
CD-ROM Drive
DDS Drive
1st Hard Disk Drive
2nd Hard Disk Drive
Notes: The floppy drive is NOT a SCSI device.
Ultra Wide SCSI
1st Hard Disk Drive
2nd Hard Disk Drive
Note: The Ultra Wide SCSI controller is set to
NOTICE: The floppy disk drive is not a SCSI device.
36
SCSI ID 7.
The SCSI controller is set to SCSI ID 7.
SCSI ID 7.
ID 6
ID 5
ID 2
ID 3
ID 6
ID 5
ID 6
ID 5