Changing The Console To External Terminal - HP Visualize b132L Service Handbook

Boot Console Interface
Displaying and Setting the Monitor Type
Next, the following message is displayed:
To select a new Graphics Monitor Type press
the <TAB> key now, otherwise EXIT by enter-
ing any other key (or will time out in 15
seconds)...
To restart the monitor selection process, press TAB.

Changing the Console to External Terminal

In the event that your console stops displaying to your
graphics device, use the following procedure to display to
console to an external terminal:
1 Turn system power off.
2 Disconnect the PC keyboard connector from the system
rear panel.
3 Connect a serial terminal to the Serial 1 connector (the
top serial connector) on the system rear panel.
4 Power on the system.
The system will now display the console to the terminal
connected to the Serial 1 port. Note that you can use a 9-pin
to 9-pin serial cable (HP F1044-80002) to connect an HP
Omnibook laptop computer serial port to the workstation.
200