Panasonic SA-DK3 Service Manual page 62

- : Deck1 CrO2 tape detect switch (ATS/
S953
CrO2)
- : Deck2 mode detect switch (MODE)
S971
- : Deck2 half detect switch (HALF)
S972
- : Deck2 CrO2 tape detect switch (ATS/
S973
CrO2)
-
: Deck2 reverse side record prevention tab
S974
detect switch / (R.REC.INH)
-
: Deck2 forward side record prevention tab
S975
detect switch / (F.REC.INH)
- : Volume control (VOLUME)
VR601
- : Jog control (JOG)
VR602
- Indicated voltage values are the standard values for the unit
meaured by the DC electronic circuit tester (high-impedance) with
the chassis taken as standard. / Therefore, there may exist some
error in the voltage values, depending on theinternal impedance of
the DC circuit tester. / No mark ............ CD STOP /
CD playback (1kHz, L+R, 0dB) /
AM / ............... DECK2 playback /
- Important safety notice: / Components identified by
special characteristics important for safety. / Furthermore, special
parts which have purposes of fire-retardent (resistors), high-quality
sound (capacitors), low-noise (resistors),etc. are used. / When
replacing any of components, be sure to use only manufacturers
specified parts shown in the parts list.
- Caution! / IC and LSI are sensitive to static electricity. / Secondary
trouble can be prevented by taking care during repair. / Ground
the soldering iron. / Put a conductive mat on the work table. / Do
not touch the legs of ICor LSI with the fingers directly.
............... FM /
............... DECK2 record
62
...............
...............
mark have