Panasonic SA-DK3 Service Manual page 58

the value of the output frequency of DECK2 FWD.
10.1.4. Bias OSC Frequency Adjustment / (Deck 2)
1. Set the unit to "AUX" position.
2. Insert the Normal blank tape (QZZCRA) into DECK2 and set the
unit to "REC" mode (use " REC/STOP" key).
3. Adjust L1201 so that the output freguency is within the standard
value. / Standard value : 98±8kHz
10.1.5. Bias Voltage Check
1. Set the unit to "AUX" position.
2. Insert the Normal blank tape (QZZCRA) into DECK2 and set the
unit to "REC" mode (use " REC/STOP" key).
3. Measure and make sure that the output is within the standard
Fig.5
Fig.6
Fig.7
58