Table of Contents
Advertisement
Hardware Reference Manual
GFK-3014E
2.2
Available Options and Accessories
The following tables list the available options and accessories for the RXi2-EP IPC.
Table 2-2
Item
R2E0N1A0A1T0A
R2E0N1C0A1T0A
R2E2N1A0A2T0A
R2E2N1C0A2T0A
Table 2-3
Item
Contact Emerson
R2X00ACCMP05
Contact Emerson
Note:
For the most current information on options and accessories, contact the nearest Emerson sales or service
office, or an authorized Emerson sales representative. Options are subject to change without notice.
2.3
ESD and EMI
Electrostatic Discharge (ESD) is the discharge of static electricity. Electromagnetic Interference
(EMI) is a disturbance generated by an external source that affects an electrical circuit by
electromagnetic induction, electrostatic coupling, or conduction. ESD and EMI issues may show
up in complete and operational systems. There are many ways to avoid problems with these
issues.
Any operational system with cables for I/O signals, connectivity or peripheral devices provides
an entry point for ESD and EMI. If Emerson does not manufacture the complete system, including
enclosure and cables, it is the responsibility of the system integrator and end user to protect
their system against potential problems. Filtering, optical isolation, ESD gaskets and other
measures might be required at the physical point of entry (enclosure wall of box or rack). For
example it is state-of-the-art that protection cannot be done at the internal connector of an RTM
if a cable is attached and routed outside the enclosure. It has to be done at the physical entry
point as specified in this document.
Products manufactured by Emerson should normally be suitable for use in properly designed
and produced customer equipment (system boxes or operational systems) without any major
redesign. However, the systems might be subject to problems and issues once assembled,
cabled and used. The end user, system integrator or installer must test for possible problems
and in some cases show compliance to local regulations as required in his country or by the
intended application.
ESD is a major cause of electronic component failure. The component has been packed in a
static-safe bag to protect it from ESD while it is in the bag. Before removing the component or
Unpacking and Inspection
Available Options
Available Accessories
Unpacking and Inspection
Description
0–slot, Quad Core 2.7 GHz, 128 GB, RJ–45
0–slot, Dual Core 2.2 GHz, 128 GB, RJ–45
2–slot, Quad Core 2.7 GHz, 128 GB, RJ–45
2–slot, Dual Core 2.2 GHz, 128 GB, RJ–45
Description
10 pcs Flat mounting kit
1 pc Flat mounting kit
1 pc Slim mounting kit
September 2021
6
Advertisement
Table of Contents
