Hp Setup Program; Device Boot Order - HP Vectra VEi7 Supplementary Manual

First, Turn On or Restart
Your PC
To Go to the Setup
Program
NOTE

HP Setup Program

Follow these instructions to check your PC's configuration when you
first use the PC:
If your PC is off, turn on the display and then the PC.
If the PC is already turned on, save your data, exit all programs and
restart your PC. For Windows NT 4.0, Windows 95 or Windows 98, use





the Shut Down Restart your computer
command will automatically exit the operating system and restart the
PC. For operating systems such as Windows NT 3.51, you must exit the
operating system, then manually switch off and then on the PC.
To go immediately into the Setup program while the Hewlett-Packard
logo appears on your display, press
The Setup program allows you to view and change the configuration of
your PC, such as the passwords, standby (power saving) mode, IRQ
settings and boot device order.

Device Boot Order

Boot Menu for the Current Startup
You can only change the current startup boot device order on VEi 7
(Celeron-equipped) models.
The current startup
attempts to start or "boot" from (for example, the floppy drive first, the
CD-ROM drive second, the hard disk drive third, and lastly the
network). From this menu you can choose the device to boot from for
the current startup.
command in the
.
F2
Boot menu gives the order of devices which the PC
1 Troubleshooting Your PC
HP Setup Program
Start menu. This
33