Advertisement
19. Install the staple-locking material/1 which is
removed in the step 13 with the removed
screws.
When installing, attach the fixing material included
in the package on the front side of staple-locking
material/1 as shown in the picture (to prevent los-
ing it).
Note:
• When moving the Finisher, be sure to install
staple-locking material/1 and all other fixing
materials. (Save all screws and locking materi-
als.)
• To prevent damage to the staple unit.
Staple locking material/1
20. Tighten the two rail-stopper fixing screws, and
put the stacker back in position.
21. Connect the two connectors of the Finisher to
the connectors on the rear left side cover of the
machine.
Finisher connectors
fixing material
15VFIXE014SA
Machine connectors
15SJIXE010SB
22. Install the Finisher on the machine.
(1) Fit the hooks on the machine installation plates
(upper and lower) into the upper and lower
holes on the Finisher as illustrated below, then
lock them by pushing the Finisher to the back.
Upper view
Finisher
Lower view
Finisher
Note:
If the gap between Finisher and machine is not
equal from the top through the bottom, adjust it by
the height of the front and rear casters on the
paper exit side of the Finisher.
E-5
Main body
Main body
A10UIXC004CA
15JKIXE003SA
Skew
adjustment
Advertisement
