HP Kayak XU04 Supplementary Manual page 56

2 Troubleshooting Your HP PC Workstation
If Your PC Workstation Has a Software Problem
8 Press when prompted to use Setup.
9 Set new User and Administrator passwords.
10 Press to save the new passwords and exit Setup.
If You Can't Start the Setup Program
This may happen if the copy of the PC Workstation's configuration
stored in CMOS is corrupted. You will need to erase this bad
configuration. Refer to "Clearing the PC Workstation's Configuration
Memory" on page 37 for more information on how to do this.
If the Date and Time Are Incorrect
The date and time can be incorrect for the following reasons:
The time has changed to reflect the beginning or end of
•
Summer Time
The PC Workstation has been unplugged from the mains for too long
•
and the battery is discharged.
The on-board battery automatically recharges itself as soon as the
PC Workstation is plugged into a power outlet.
To change the date and time, use your operating system utilities or the
Setup program.
If You Have a Network Problem
If you have a problem with your PC Workstation's network, run the
HPIEDIAG utility provided on the HP CD-ROM that contains the LAN
drivers, supplied with your PC Workstation. This utility should be run
from a minimal DOS system, without any LAN drivers loaded—achieve
this by booting from a system floppy disk. (If your PC Workstation is
running Windows NT 4.0, you will need to create this system floppy
disk on another PC.)
1 Insert the system floppy disk in the floppy disk drive and re-boot
your PC Workstation.
48 English