When a SCSI Hard
Disk Drive Is Installed
When an IDE Drive
Is Installed
1 How to Install Accessories In Your HP PC Workstation
Installing Mass Storage Devices
7 Locate the appropriate data cable for the disk drive (refer to
page 8).
To improve access, you may need to disconnect any devices already
connected to the SCSI cable and allow the cable to hang outside the
of the PC Workstation's case.
8 Connect the data and power cables to the rear of the device. (The
connectors are shaped to go in one way only.)
Data Cable
9 Replace the HP UltraFlow airflow guide (refer to page 5).
10 Install any other accessories before replacing the cover and
completing the installation.
11 Follow the instructions below to complete the installation.
Completing the Installation of a Hard Disk Drive
For more information on completing the installation of a SCSI hard disk
drive, refer to the SCSI Administrator's Guide available on HP's web
site at
http://www.hp.com/go/kayaksupport
1 Switch on the computer.
2 To display the device in POST, press
re-starts.
14
English
Power Cable
.
while the PC Workstation